Professional 3D Resin for Making Jewelry Rubber / Liquid/ Silicon Mold
Great details with surface
Non sticky to jewelry mold
Rubber mold resin high temperature resistance 220 ℃
Several option for DLP LCD printer
Jewelry Molding Resin Model details
DLP Printer:
Silicon /liquid mold use pjhe-29
Ruber mold use HTE-29
LCD printer:
Silicon /liquid mold use pjhc-29
Ruber mold use HTC-29
If you are not sure your printer, send us your printer specification, or printer brand with model number, then we can arrange the right model for you.
Printing Parameter
Only have to set the exposure times according the layer height, and leave the rest as it was.
If you are not sure, reach us with your printer brand and so o
POST CURING
1. The curing time is proportional to the volume of the work piece and inversely proportional to the optical power of the curing chamber. Example: 100 watt LED curing box, jewelry jobs is recommended to be cured with soaking in water for 20-30 minutes.
2. The post-cure time of dental casting resin, dental non-casting resin and jewelry mold resin shall not more than 5 minutes.
3. Work-pieces should be in the water during post-curing to prevent deformation especially for dental and jewelry.
4. Don’t forget to use cool air to dry it after post-curing.
Cleaning
Step1, Spray with Isopropanol, then blow resin away with cool wind.
Step2, Prepare two containers with Isopropanol (alcohol> 95%), and place the jobs into the first container and slightly shake it, then soak in the second container for about 1 minute (dental resin should not exceed 30 seconds).
Step3, Flush with water before dry it, do make it sure it ‘s 100% dried as residuary alcohol may cause white spot or crack on jobs.
Warning
1.This material should not be in contact with eyes, skin or clothing, and should not be tasted or eaten.
2.If you accidentally touch your eyes or skin, immediately rinse with water for about 20 minutes and seek medical advice if necessary.
3. Please pay attention to air circulation and take protective measures when using. Wash thoroughly after handling.
4. The product is in a liquid state with a slight odor. Wear a mask and gloves.
5. The product should be stored in a sealed container. After use, it should be filtered and keep back in bottle on time and placed in a dry and well ventilated place. It should not be exposed to sunlight.
6. Shake well before use, and leave it for 30 minutes to eliminate air bubbles that generated during the shaking process.
7. The ambient temperature is recommended to be controlled at 25-30 degrees Celsius, and during the printing should avoid any lights.
8. Dispose of waste in accordance with local environmental regulations.
9. Storage environment: Store in cool and dry place, and avoid sunlight, recommended temperature at 25-30 degrees Celsius.
