55W 35W HID xenon kit H1 H3 H4 H7 H11 9005 9006 car headlight slim ballast xenon bulb 4300K 6000K 8000K xenon H7 Kits
1. HID Bulb
2. Voltage Input: 12V
3. Power Output : 55W or 35W
4. Cold start current: <4.50A
5. Working Current: 3.35-3.55A
6. Case Temperature: -40±105 degree
7. Service Life: More than 3,200 hours
8. Compatibility: Car, motorcycle, electric motor car
9. Main Package Includes:
(1)The Single beam lamp
(H1,H3,H7,H11,880,9005,9006,H4 single):
2 x Headlight Bulbs,
2 x Ballasts,
1 x Box
(2)The Hi/Lo beam lamp
(9004,9007,H13,H4 Hi/Lo ):
2 x Headlight Bulbs,
2 x Ballasts,
1 x Wiring Harness Controller,
1 x Box
(3)D2S Socket Type:
2 x Headlight Bulbs,
2 x Ballasts,
2x Wiring Harness Socket Adapters,
1x Box
10. Warranty:2 years
All temp color:
3000K Gold Yellow
4300K White Yellow
5000k Warm White
6000K Cold White
8000K White Blue
Best for car, most Brightness for car !
10000K Blue
12000K Deep blue
FAQ
1.Issue: HID or LED kit fails to switch on?
Solutions:You may have a reverse polarity issue. If you're using an HID kit: Rotate the ballast input (red or black oval) 2-pin connector 180 degrees. Increase the fuses (both in the car fuse box and the relay harness) to 20A. Check all connections. Check the grounds (if the HID kit is installed with the relay wiring harness)
Issue: HID lights flicker?
Solutions: If you have a single beam and low xenon / high halogen headlights: Install a relay harness with load resistors. Disable the DRL and/or automotive lights. Increase the fuse strength both in the car fuse box and the relay harness to 20A.
Check all the connections. Clean them if necessary.
Check the car battery. It should be delivering a minimum of 12V.
If you're using a BI-XENON: Install load resistors; the links are as follows: H4 / 9003, H13 / 9008, 9004 / HB1, 9007 / HB5.
Issue: Only one side of the HID headlights is working?
Solutions: Check all the connections. Clean them if necessary. Check if the bulb or ballast is faulty (i.e. swapping the bulbs to test if it works on other side).
.Issue: The HIDs work when the engine is off, but the lights shut down when you start your car?
Solution: Install a relay harness with load resistors.
.Issue: Why did not I get the wire as picture showing?
Only 4 Models in need of extra connect wire so you will not get wire if out of the 4 models.
The 4 models are:
H4 Hi Low;
H13 Hi Low;
9004 Hi Low;
9007 Hi Low.