Daly Smart BMS 3S-24S Li-Ion LiFePo4 With Bluetooth 4S 7S 8S 12S 13S 14S 15S 16S 17S 20S For Lithium Battery Pack
Good News: Cut in Jun 06 08 China Time,
Customer place the smart BMS using this link, the bluetooth with active switch function as below picture, then the smart BMS will be easily actived only the wire connection 100% correct.
*This link inlcuding the bluetooth & USB UART cable you buy the BMS
If power display board ( active BMS board) or other accessary, Please contact me or use other link to buy it. Thanks a lot.
4S BMS only can use one function from BT & LCD & RS485, such as you choose BT, you can not use LCD or RS485. because 4S with Design limited, Please don't buy active BMS board) or other accessary
Above 5S. the BMS can use the LCD , the buy link===>LCD and CAN
Above 5S, the BMS can use the power display board. the buy link==>power display and other accessaryh
◆UART : it is Daly normal product. UART isUniversalAsynchronousReceiver/Transmitter,It transforms the data to be transmitted between serial communication and parallel communication. As a chip to convert parallel input signals into serial output signals, UART is usually integrated into other communication interfaces.
◆ 485:Please choose the model UART 485 of Daly. RS-485 adopts balanced transmission and differential reception, so it has the ability to suppress common mode interference.
◆Strong load ability, constant discharge current 80A 100A 120A 150A 250A, , use high voltage resistance, low inner resistance power Mosfet. The heat sink will greatly help cooling.
◆The cable starts from the black thin wire connecting B-, the second wire (the thin red wire) is connected to the positive pole of the first battery, and the positive pole of each battery is connected in turn until the last red wire is connected to B+;
◆After connecting the wire, mustn't insert the plug directly into the BMS. Measure the voltage between each two adjacent metal terminals on the back of the plug. If the voltage of the terpolymer battery should be between 2.8V and 4.2V, the iron-lithium battery should be between 2.5V and 3.65V.
◆After correct wiring sequence and voltage confirmation, insert the BMS socket.
◆The protective board B line (blue thick line) is connected to the negative pole of the battery pack.
◆After the wiring is completed, measure whether the total voltage of the battery pack and the total voltage passing through the BMS are equal. If they are different, check again according to the above wiring sequence.
For 30A 40A and 60A there are 2 sizes. Please note it . Thanks a lot.