Overview of the characteristics:
1.GSM 850/900/1800/1900MHZ.
2.GPS position.
3.Auto set APN.
4.200Mah Battery inside, Power-Cut alarm.
5.Motion detect, save GPRS flow and power.
6.GEO-fence alarm.
7.SOS Alarm.
8.Shock Alarm.
9.ACC Alarm.
10.Speed Alarm
11.Voice Surveillance.
12.Voltage DC 9-40V.
13.Enginee Cut off.
Specification:
1).GSM:850/900/1800/1900MHZ
2).GPRS: Class12, TCP/IP
3).Working Voltage:9-40V DC
4).Working current:≈22mA (12VDC)
5).Working current:≈12mA (24VDC)
6).GPS locating time:Cold start≈38s(Open sky)
Warm start≈32s
Hot start≈2s(Open sky)
7).GPS Precision:10m(2D RM)
8).Working temperature:-20℃~+70℃
9).Working humidity:20%~80%RH
10).Measurement:98(L)×52(W)×16.5(H)mm
Device status indicators
1 Connect DC 9-40V power supply,push the switch(switch beside the sim card holder), the red LED will light continuously.
2 The blue LED light continuously when searching the GPS signals. When GPS position,the blue LED flashing.
3 The intermediate green LED (GSM signal state)
GSM signal is normal, green LED flashing. No GSM signal, the green LED light continuously.
4 If work normal, after 5 minutes, all LED go off.
All LED will turn off after 5 minutes. When there is a new call, the LED will relight and turn off 5 minutes.
Installation
Prepare for installation
1 Product Check. Open the packing box and check the device’s model and accessories. If the model is wrong or the accessories not complete, please contact the dealer.
2 Choose SIM card. Please insert a SIM card which support GSM 2G network to the device. Please take dealer’s advice as reference.
3 SIM card installation. Discharge the cover of the device and uncover the SIM card holder. Then insert the SIM card and cover SIM card holder (as follows).
4 Open the cover, Push the switch. Then Put back the front cover.
5 Connect the device to the 9-40V power supply.
6 Install the device in the hidden place of the car;
The SIM card must be with GPRS function and enough deposit. If your SIM card need input PIN when power on, please cancel it.
Installation:
The GPS tracker must be installed under professional personnel.
Note:
1) Please install the device in the hidden place as followings:
2) Avoid being placed with signal radiators like reverse sensor ;
3) The device has GSM antenna and GPS antenna inside. Please ensure the receiving side of the device is face up and without metal cover.
Note: The metal cover will lessen the receiving of GPS signals.
Device wiring requirements:
1 The device power supply is DC 9-40V. The red line is positive pole while the black line is negative pole.
2 The negative pole of power supply connects with ground or the metals. Please do not connect with other ground lines.
3 When finishing the power supply wire connection, please make the plug of power supply to the device.
Manual Download By QR Code: